Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to next step
1		No	Record FREEZE FRAME DATA on the repair order, then go to next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins availability. Is any related Service Bulletins available?	Yes	Perform repair or diagnosis according to available Service Bulletins If vehicle is not repaired, go to next step.
2		No	Go to next step
3	VERIFY THE SELECTOR LEVER POSITION Was the selector lever position in P or N position during the KOEO/KOER self-test?	Yes	Go to next step
3		No	Perform the KOEO/KOER self-test Then go to Step 5
4	VERIFY STORED DTC IN TCM Switch the ignition to ON (Engine off). Verify stored DTCs in TCM (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [AW6A-EL] .) Are DTCs stored?	Yes	Go to the appropriate DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL] .) (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [AW6A-EL] .)
4		No	Go to the next step.
5	VERIFY TROUBLESHOOTING OF DTC P1705:00 HAS BEEN COMPLETED Verify that all disconnected connectors reconnected. Clear DTC from memory using M-MDS Perform KOEO/KOER Self-Test Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to next step. (See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
5		No	Go to next step
6	VERIFY AFTER REPAIR PROCEDURE Perform "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE [MZI-3.7] ) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZI-3.7] .)
6		No	Troubleshooting completed.