After Repair Procedure [MZI-3.7]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.

Fig 1: Locating DLC-2 Data Link Connector

Courtesy of MAZDA MOTORS CORP.

After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "Self Test".
  2. Select "Modules"
  3. Select "PCM"
  4. Select "Retrieve CMDTCs"
- When using the PDS (Pocket PC)
  1. Select "Module Tests"
  2. Select "PCM".
  3. Select "Self Test".
  4. Select "Retrieve CMDTCs".
Verify the DTC according to the directions on the M-MDS screen.
Press the clear button on the DTC screen to clear the DTC
Verify that no DTCs are displayed.