Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to next step.
1		No	Record FREEZE FRAME DATA on the repair order, then go to next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins availability Is any related Service Bulletins available?	Yes	Perform repair or diagnosis according to available Service Bulletins. If vehicle is not repaired, go to next step
2		No	Go to next step.
3	VERIFY THE BRAKE PEDAL WAS APPLIED Was the brake pedal applied and released during the KOEO self-test?	Yes	Go to next step.
3		No	Perform the KOER self-test. Apply and release the brake pedal during the KORE test, then go to Step 10 (See KOEO/KOER SELF TEST [MZI-3.7] .)
4	INSPECT THE OPERATION OF THE BLAKE/TAILLIGHT Switch the ignition ON (Engine off) Depress and release the brake pedal and check the brake/taillight operation Do the brake/taillight operate correctly?	Yes	Go to next step.
4		No	Repair or replace harness or brake/taillight, then go to Step 10.
5	INSPECT THE CRUISE CONTROL OPERATION Check for cruise control operation Does the cruise control operate correctly?	Yes	Go to next step.
5		No	Repair or replace suspected part, then go to Step 10.
6	INSPECT BRAKE SWITCH AND PCM CONNECTOR FOR POOR CONNECTION Switch the ignition off. Disconnect the brake switch connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Are there any malfunction?	Yes	Repair or replace suspected part, then go to Step 10.
6		No	Go to the next step.
7	INSPECT BRAKE SWITCH NO. 1 CIRCUIT MALFUNCTION Switch the ignition ON (Engine off) Measure the voltage between PCM terminal 1S (wiring harness-side) and body ground Verify the following values when the brake pedal to the floor and releasing Brake pedal fully depressed. more than 10 V Brake pedal fully released. less than 10 V Is the voltage normal?	Yes	Go to next step
7		No	Repair or replace suspected part, then go to Step 10.
8	INSPECT BRAKE SWITCH Inspect the brake switch (See BRAKE SWITCH INSPECTION .) Is there any malfunction?	Yes	Repair or replace suspected part, then go to Step 10.
8		No	Go to the next step.
9	INSPECT FOR CORRECT PCM OPERATION Disconnect all the PCM connectors. Visually inspect for: Pushed out pins Corrosion Connect all the PCM connectors and verify that they seat correctly. Retrieve DTCs using the M-MDS. Is the PENDING CODE for this DTC present?	Yes	Go to the next step.
9		No	The system is correctly. Go to the next step
10	VERIFY TROUBLESHOOTING OF DTC P1703:00 HAS BEEN COMPLETED Verify that all disconnected connectors reconnected. Clear DTC from memory using M-MDS. Perform "KOEO/KOER Self-Test". (See KOEO/KOER SELF TEST [MZI-3.7] .) Is PENDING CODE same as DTC present?	Yes	Replace the PCM, then go to next step. (See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
10		No	Go to next step.
11	VERIFY AFTER REPAIR PROCEDURE Perform "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE [MZI-3.7] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection (See DTC TABLE [MZI-3.7] .)
11		No	Troubleshooting completed