LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 632 (On-Board Diagnostic (Engine Control System MZI-3.7) (5 Of 5)) >> DTC P1501:00 [MZI-3.7] >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related Service Bulletins available?
 Yes Perform repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY STORED DTC IN DSC/RSC HU/CM 
  • Switch the ignition ON (Engine off).
  • Verify stored DTCs in DSC/RSC HU/CM
  • Are DTCs stored?
 Yes Go to the appropriate DTC inspection.
(See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
No Go to the next step.
4 VERIFY TROUBLESHOOTING OF DTC P1501:00 HAS BEEN COMPLETED 
  • Verify that all disconnected connectors reconnected.
  • Clear the DTC from the PCM memory using the M-MDS
  • Perform the "KOEO or KOER self-test" using the M-MDS.

    (See KOEO/KOER SELF TEST [MZI-3.7] .)

  • Is the PENDING CODE for the DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection
(See DTC TABLE [MZI-3.7] .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals