Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step
1		No	Record FREEZE FRAME DATA on the repair order, then go to the next step
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability Is any related Service Bulletins available?	Yes	Perform repair or diagnosis according to the available Service Bulletins If the vehicle is not repaired, go to the next step.
2		No	Go to the next step
3	INSPECT GENERATOR TERMINAL FOR POOR INSTALLATION Switch the ignition off. Inspect generator terminal B for looseness Are there any malfunction?	Yes	Connect generator terminal B correctly, then go to Step 9.
3		No	Go to the next step
4	INSPECT GENERATOR CIRCUIT FOR SHORT TO POWER SUPPLY Switch the ignition ON (Engine off). Measure the voltage between the following terminals. Generator terminal RC (wiring harness-side) and body ground. Generator terminal LI (wiring harness-side) and body ground. Is the voltage B+?	Yes	Repair or replace suspected part, then go to Step 9.
4		No	Go to the next step.
5	INSPECT PCM CONNECTOR FOR POOR CONNECTION Switch the ignition off. Inspect for poor connection (such as damaged/pulled-out terminals, corrosion). Are there any malfunction?	Yes	Repair or replace suspected part, then go to Step 9.
5		No	Go to the next step.
6	INSPECT GENERATOR CIRCUIT FOR OPEN CIRCUIT Inspect for continuity between generator terminal RC (wiring harness-side) and PCM terminal 1BF (wiring harness-side) Is there continuity?	Yes	Go to the next step.
6		No	Repair or replace suspected part, then go to Step 9.
7	INSPECT BATTERY POSITIVE TERMINAL FOR POOR INSTALLATION Switch the ignition off. Inspect the battery positive terminal for looseness. Is there any malfunction?	Yes	Connect the battery positive terminal correctly, then go to Step 9.
7		No	Go to the next step.
8	INSPECT GENERATOR CIRCUIT FOR OPEN CIRCUIT Inspect the continuity between generator terminal B (wiring harness-side) and battery positive terminal (wiring harness-side) Is there continuity?	Yes	Go to the next step.
8		No	Repair or replace suspected part, then go to the next step
9	VERIFY TROUBLESHOOTING OF DTC P0626:00 HAS BEEN COMPLETED Verify that all disconnected connectors reconnected Clear the DTC from the PCM memory using the M-MDS Perform the KOEO or KOER self-test using the M-MDS (See KOEO/KOER SELF TEST [MZI-3.7] .) Is the PENDING CODE for the DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
9		No	Go to the next step.
10	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE [MZI-3.7] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZI-3.7] .)
10		No	Troubleshooting completed.