LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (On-Board Diagnostic (Engine Control System MZI-3.7) (4 Of 5)) >> DTC P060D:00 [MZI-3.7] >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability
  • Is any related Service Bulletins available?
 Yes Perform repair or diagnosis according to the available Service Bulletins
  • If the vehicle is not repaired, go to the next step
No Perform the PCM reprogramming procedure.
(See PCM CONFIGURATION [MZI-3.7] .) Then go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P060D:00 HAS BEEN COMPLETED 
  • Verify that all disconnected connectors are reconnected
  • Switch the ignition to ON (Engine off)
  • Clear the DTC from the PCM memory using the M-MDS
  • Start the engine and perform the KOEO and KOER self-test
  • Retrieve DTCs using the M-MDS.
  • Is the PENDING CODE for this DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.7] .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals