LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (On-Board Diagnostic (Engine Control System MZI-3.7) (4 Of 5)) >> DTC P060A:00, P060C:00, P061D:00 [MZI-3.7] >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability
  • Is any related Service Bulletins available?
 Yes Perform repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT PCM FOR LATEST CALIBRATION 
  • Program the PCM to the latest calibration.
  • Switch the ignition off.
  • Perform the KOEO self-test.
  • Switch the ignition off
  • Perform the KOER self-test
  • Use the customer information to recreate the concern
  • Perform the self-test.
  • Are DTCs P060A:00, P060C:00 or P061D:00 present?
 Yes Go to the next step.
No Go to Step 5.
4 INSPECT FOR CORRECT PCM OPERATION 
  • Disconnect all the PCM connectors
  • Visually inspect for
    • Pushed out pins
    • Corrosion
  • Connect all the PCM connectors and verify that they seat correctly.
  • Retrieve DTCs using the M-MDS
  • Is the PENDING CODE for this DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
No Go to the next step.
5 VERIFY TROUBLESHOOTING OF MISFIRE DTC P060A:00, P060C:00 AND P061D:00 HAS BEEN COMPLETED 
  • Verify that all disconnected connectors reconnected
  • Switch the ignition ON (Engine off).
  • Clear the DTC from the PCM memory using the M-MDS.
  • Perform the "KOEO and KOER self-test"

    (See KOEO/KOER SELF TEST [MZI-3.7] .)

  • Retrieve DTCs using the M-MDS.
  • Is the PENDING CODE for this DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.7] .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals