LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 630 (On-Board Diagnostic (Engine Control System MZI-3.7) (3 Of 5)) >> DTC P0454:00 [MZI-3.7] >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related Service Bulletins available?
 Yes Perform repair or diagnosis according to the available Service Bulletins.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step
3 VERIFY RELATED PENDING CODE OR STORED DTCs 
  • Switch the ignition off then to the ON position (Engine off).
  • Verify related pending code or stored DTCs.
  • Is other DTCs present?
 Yes Go to the appropriate DTC troubleshooting.
(See DTC TABLE [MZI-3.7] .)
No Perform the "INTERMITTENT CONCERN TROUBLESHOOTING" Then go to the next step.
4 VERIFY TROUBLESHOOTING OF DTC P0454:00 HAS BEEN COMPLETED 
  • Verify that all disconnected connectors reconnected.
  • Clear the DTC from the PCM memory using the M-MDS
  • Perform the "KOEO or KOER self-test" using the M-MDS

    (See KOEO/KOER SELF TEST [MZI-3.7] )

  • Is the PENDING CODE for the DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [MZI-3.7] )
No Troubleshooting completed.
scientia non olet · About LEMON Manuals