LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (On-Board Diagnostic [Suspension System - Tire Pressure Monitoring System)) >> Tire Pressure Monitoring System (TPMS) On-Board Diagnosis >> Reading DTCs Procedure

Reading DTCs Procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Self Test".
      2. Select "Modules".
      3. Select "IC".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "IC".
      3. Select "Self Test".
    Fig 1: Identifying DLC-2
    G06205362Courtesy of MAZDA MOTORS CORP.
  3. Verify the DTC according to the directions on the screen.
    • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
  4. After completion of repairs, clear all DTCs stored in the instrument cluster. See DTC TABLE [INSTRUMENT CLUSTER] .
scientia non olet · About LEMON Manuals