LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 607 (Washer System & Wiper System) >> Washer Fluid-Level Sensor Removal/Installation

Washer Fluid-Level Sensor Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the front bumper. See FRONT BUMPER REMOVAL/INSTALLATION .
  3. Remove the washer tank. See WASHER TANK REMOVAL/INSTALLATION .
  4. Remove in the order indicated in the table.
    Fig 1: Identifying Washer Fluid-Level Sensor And Grommet
    G06199546Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals