LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Automatic Transaxle [Service, Removal & Installation FS5A-El)) >> Solenoid Valve Removal/Installation [FS5A-El] >> Secondary Control Valve Body

Secondary Control Valve Body

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the secondary control valve body.
    1. Disconnect the negative battery cable.
    2. Remove the battery and battery tray.
    3. Remove the PCM and PCM bracket. (See PCM REMOVAL/INSTALLATION [L5] .)
    4. Remove the aerodynamic under cover NO. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
    5. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents
    6. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL] .)
    7. Remove the oil cover. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [FS5A-EL] .)
    8. Remove the secondary control valve body. (See CONTROL VALVE BODY REMOVAL/INSTALLATION [FS5A-EL] .)
  2. Remove in the order indicated in the table.
    Fig 1: Pressure Control Solenoid B & Shift Solenoid F With Torque Specifications
    G06205901Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
  4. Add ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [FS5A-EL] .)
  5. Perform the "Mechanical System Test" (See MECHANICAL SYSTEM TEST [FS5A-EL] .)
  6. Perform the "Road Test" (See ROAD TEST [FS5A-EL] .)
scientia non olet · About LEMON Manuals