Off-Vehicle Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between input/turbine speed sensor terminals A and B.
- If there is any malfunction, replace the input/turbine speed sensor (See INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL] .)
  Input/turbine speed sensor specification 250-600 ohms
  
  Fig 1: Identifying Input/Turbine Speed Sensor Connector Terminal
  Courtesy of MAZDA MOTORS CORP.