Input/Turbine Speed Sensor Removal/Installation [FS5A-El]
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage.
- A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.
- Disconnect the negative battery cable.
- Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L5] .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.