Diagnostic procedure

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has the FREEZE FRAME DATA been recorded on the repair order?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT COUPLER COMPONENT CONNECTOR FOR POOR CONNECTION Switch the ignition off. Disconnect the coupler component connector. Inspect for poor connection (such as damaged/pulled-out pins, corrosion) Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 5.
3		No	Go to the next step.
4	INSPECT TFT SENSOR Inspect the TFT sensor. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION [FS5A-EL] .) Is there any malfunction?	Yes	Replace the coupler component, then go to next step. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [FS5A-EL] .)
4		No	Go to the next step.
5	VERIFY TROUBLESHOOTING OF DTC P0711:00 COMPLETED Make sure to reconnect all the disconnected connectors. Clear the DTC using the M-MDS. Perform the following procedure to ensure that the DTC has been resolved: Start the engine. Idle the engine for 180 s or more. Drive the vehicle at within 25-59 km/h {16-36 mph} for 90 s or more. Drive the vehicle at more than 60 km/h {37 mph} for 60 s or more. Is the same DTC present?	Yes	Replace the TCM, then go to the next step. (See TCM REMOVAL/INSTALLATION [FS5A-EL] .)
5		No	Go to the next step.
6	VERIFY NO DTC HAS BEEN PRESENTED Perform the "Reading DTCs Procedure". (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [FS5A-EL] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [FS5A-EL] .)
6		No	DTC troubleshooting completed.