Solar Radiation Sensor Removal/Installation [Full-Auto Air Conditioner]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the driver's side lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
CAUTION:
- After the solar radiation sensor removal, the sensor connector could fall in the dashboard making the installation difficult. Therefore, hold the rooted end of the sensor connector using a clip or similar tool to prevent it from falling.
Remove in the order indicated in the table.

Fig 1: Identifying Solar Radiation Sensor Connector And Solar Radiation Sensor
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.