LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Engine Control System (MZI-3.7)) >> Throttle Position (TP) Sensor Inspection [MZI-3.7] >> Sensor Output Value Inspection

Sensor Output Value Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that no DTC related to APP sensor has been detected.
    • If any DTCs related to APP sensor have been detected, perform the DTC inspection. See DTC TABLE [MZI-3.7] .
  2. Switch the ignition to ON.
  3. Inspect the following items using the PID/DATA monitor function. See DIAGNOSTIC MONITORING TEST RESULTS [MZI-3.7] .
    • Verify that the sensor output value is as indicated in the table below according to the condition of the accelerator pedal.
      • TP1
      • TP2

        Specification 

        SPECIFICATION

        Condition TP1 TP2
        Accelerator pedal is released 3.7-4.7 0.3-1.9
        Accelerator pedal is depressed 0 7-2.9 4.1-4.7
    • If it cannot be verified, replace the throttle body. See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZI-3.7] .
scientia non olet · About LEMON Manuals