LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Entertainment System) >> Auxiliary Jack Inspection

Auxiliary Jack Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts.
    1. Upper panel. See UPPER PANEL REMOVAL/INSTALLATION .
    2. Shift knob (MTX). See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .
    3. Shift panel. See SHIFT PANEL REMOVAL/INSTALLATION .
    4. Decoration panel. See DECORATION PANEL REMOVAL/INSTALLATION .
    5. Center panel lower. See CENTER PANEL LOWER REMOVAL/INSTALLATION .
    6. Rear console. See REAR CONSOLE DISASSEMBLY/ASSEMBLY .
    7. Auxiliary jack. See AUXILIARY JACK REMOVAL/INSTALLATION .
  3. Connect a commercially-available nonresistant plug to the auxiliary jack.
  4. Verify that the continuity between the auxiliary jack terminals is as indicated in the table.
    Fig 1: Test Condition Terminal Chart
    G06201202Courtesy of MAZDA MOTORS CORP.
    Fig 2: Connecting Commercially-Available Nonresistant Plug To Auxiliary Jack
    G06201203Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the auxiliary jack
scientia non olet · About LEMON Manuals