Manifold Absolute Pressure (Map) Sensor Inspection [L5]
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON.
- Verify that the voltage (M-MDS PID: MAP) within the specification. (See
PCM INSPECTION [L5] .)
- If not as specified, replace the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [L5] .)