Manifold Absolute Pressure (Map) Sensor Removal/Installation [L5]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [L5] .)
Disconnect the MAP sensor connector.
Remove the MAP sensor.
Install in the reverse order of removal.

Fig 1: MAP Sensor Connector & Intake Manifold With Torque Specifications
Courtesy of MAZDA MOTORS CORP.