LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (Lighting System) >> Rear Turn Light Bulb Removal/Installation

Rear Turn Light Bulb Removal/Installation

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  3. Partially peel back the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  4. Disconnect the connectors shown in the figure.
    Fig 1: Identifying Connectors
    G06201060Courtesy of MAZDA MOTORS CORP.
  5. Rotate the rear turn light socket in the direction of the arrow shown in the figure and remove it.
    6. Fig 2: Rotating Rear Turn Light Socket
    G06201061Courtesy of MAZDA MOTORS CORP.
  6. Remove the rear turn light bulb.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals