Resistance Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Disconnect the EGR valve connector.
- Measure the resistance between the EGR valve terminate.
RESISTANCE REFERENCE CHART
| EGR valve terminal | Resistance inspection (ohm) |
|---|---|
| C-A D-B C-E D-F |
12-16 (At room temperature) |
- If not within the specification, replace the EGR valve. (See EGR VALVE REMOVAL/INSTALLATION .)