LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (Service Information MZR 2.5)) >> Engine Tune-Up >> Idle-up Speed Control Inspection

Idle-up Speed Control Inspection

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Idle speed is not adjustable.
  • Idle speed verification requires M-MDS.
  1. Complete the engine tune-up preparation. (See ENGINE TUNE-UP PREPARATION .)
  2. Verify that the engine speed (M-MDS: RPM) is within the specification when each load is applied. (The speed decrease just after the load is applied is not considered.)
    • If the engine speed is not within the specification when a specified load is applied, inspect the related input parts, wiring harnesses, and connectors.

    Idle-up speed (ATX: P, N position, MTX: Neutral position) 

    A/C on : 600-850 RPM 

    Electrical loads on: 650-750 RPM (MTX), 600-750 RPM (ATX) 

    While turning steering wheel: 650-750 RPM 

scientia non olet · About LEMON Manuals