LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (Service Information MZR 2.5)) >> Engine Tune-Up >> Engine Tune-up Preparation

Engine Tune-up Preparation

WARNING: This page is about a different variant/trim than selected.
  1. Verify the following:
    • ATX: Selector lever is in P or N position.
    • MTX: Shift lever is in neutral position.
  2. Warm up the engine to normal operating temperature.
    1. Increase the engine speed to 2,500-3,000 RPM  until the cooling fan starts running.
    2. When the cooling fan starts running, release the accelerator pedal and wait until the cooling fan stops running.
  3. Turn off all electrical loads.
  4. Connect the M-MDS to the DLC-2.
    Fig 1: DLC-2
    G06199854Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals