LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (Service Information MZR 2.5)) >> Drive Belt Removal/Installation

Drive Belt Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set the front mudguard (RH) out of the way. (See FRONT MUDGUARD REMOVAL/INSTALLATION .)
  2. Remove the splash shield (RH).
  3. Rotate the drive belt auto tensioner in the direction shown in the illustration and remove the drive belt.
  4. Install the drive belt.
  5. Install the splash shield (RH).
  6. Install the front mudguard (RH). (See FRONT MUDGUARD REMOVAL/INSTALLATION .)
    Fig 1: Rotating Drive Belt Auto Tensioner
    G07620317Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals