Throttle position (TP) sweep inspection

1. Connect the M-MDS to the DLC-2.
2. Switch the ignition to ON.
3. Verify that none of the following DTC are displayed: (See ON-BOARD DIAGNOSTIC TEST .)
   • P0122:00, P0123:00, P0222:00, P0223:00, P0638:00, P2100:00, P2101:00, P2107:00, P2108:00, P2119:00, P2122:00, P2123:00, P2127:00, P2128:00, P2135:00, P2138:00
   • If any one DTC is displayed, perform DTC inspection. (See DTC TABLE .)
4. Access the PCM PIDs APP1 and APP2 using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST .)
5. Verify the APP1 and APP2 PIDs when the accelerator pedal released and depresses.

Specification 

• Accelerator pedal released:
  • APP1: Approx. 0.4 V 
  • APP2: Approx. 0.4 V 
• Accelerator pedal depressed:
  • APP1: Approx. 3.4 V 
  • APP2: Approx. 3.4 V 
• If not as specified, inspect for the following harnesses and connectors:

• APP sensor terminal A-PCM terminal 1W
• APP sensor terminal B-PCM terminal 1AP
• APP sensor terminal C-PCM terminal 1AV
• APP sensor terminal D-PCM terminal 1AS
• APP sensor terminal E-PCM terminal 1AO
• APP sensor terminal F-PCM terminal 1AL

• If there is no malfunction, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION .)