Brake override system operation inspection

WARNING: This page is about a different variant/trim than selected.

NOTE:

If the brake override system operates normally after performing the following inspection, the PCM detects DTC P2299:00.

Start the engine and run it is idling.
Verify that the engine speed becomes less than 1,100 RPM under the following conditions.

Neutral (MTX)
P or N position (ATX)
Engine speed of 1,150 RPM or more other than idle
Brake pedal depressed

If the engine speed becomes less than 1,100 RPM , clear the PCM DTC using the M-MDS. (System operation is normal.) (See ON-BOARD DIAGNOSTIC TEST .)
If the engine speed does not become less than 1,100 RPM, inspect for the following parts, then repair or replace the malfunctioning part:

APP sensor (See ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION .)
Neutral switch (MTX) (See NEUTRAL SWITCH INSPECTION .)
CPP switch (MTX) (See CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION .)
TR switch (ATX) (See TRANSAXLE RANGE (TR) SWITCH INSPECTOR .)
Brake switch No. 1 (See BRAKE SWITCH INSPECTION .)
Brake switch No. 2 (See BRAKE SWITCH INSPECTION .)
Communication between PCM and TCM (ATX) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .)