Crankshaft Position (CKP) Sensor Removal/Installation: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
Perform the following procedure for easier access.
1. Remove the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
2. Remove the splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION .)
Disconnect the CKP sensor connector.
Remove the CKP sensor.

Fig 1: CKP Sensor And Bolts

Courtesy of MAZDA MOTORS CORP.