Air Gap Inspection

WARNING: This page is about a different variant/trim than selected.

Verify that the CKP sensor is securely installed.
Using a thickness gauge, measure the air gap between the plate projections at the back of crankshaft pulley and the CKP sensor.
- If not within the specification, inspect the plate projections for cracks or bending.
- If there is any malfunction, replace the crankshaft pulley. (See FRONT OIL SEAL REPLACEMENT .)
Air gap

0.5-1.5 mm {0.02-0.05 in}

Visual Inspection
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
2. Perform the following procedure for easier access.
  1. Remove the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  2. Remove the splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION .)
3. Disconnect the CKP sensor connector.
4. Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION .)
5. Verify that there are no metal shavings on the sensor.
- If there is a malfunction, remove any metal shavings that are adhering.