Generator Warning Light
WARNING: This page is about a different variant/trim than selected.
- Verify that the battery is fully charged.
- Verify that the drive belt is correct. (See DRIVE BELT INSPECTION [MZR 2.5] .)
- Switch the ignition to ON, verify that the generator warning light illuminates.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
- If the generator warning light and the wiring harness are normal, inspect the PCM.
- Verify that the generator warning light goes out after the engine is started.
- If the generator warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) (See DTC TABLE [MZR 2.5] .)