Rear Combination Light Removal/Installation

1. Disconnect the negative battery cable.
2. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
3. Partially peel back the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
4. Disconnect the connectors shown in the illustration and remove the nuts.
   Fig 1: Rear Combination Light Connectors And Nuts With Torque Specification

   Courtesy of MAZDA MOTORS CORP.
5. Pull the rear combination light in the direction of the arrow to detach it from the tab.
6. Remove the rear combination light.
7. Install in the reverse order of removal.

Fig 2: Pulling Rear Combination Light

Courtesy of MAZDA MOTORS CORP.