Diagnostic Procedure
DTC U0533:68 [INSTRUMENT CLUSTER] DIAGNOSTIC PROCEDURE
| STEP | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM BSM CONTROL MODULE DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [BLIND SPOT MONITORING (BSM)] .) |
| No | Go to the next step. | ||
| 2 | PERFORM INSTRUMENT CLUSTER DTC INSPECTION
|
Yes | Replace the BSM control module (LH), then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY THAT NO OTHER DTCs ARE RECORDED
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | DTC troubleshooting completed. | ||