DTC Inspection [Instrument Cluster]

Connect the M-MDS (IDS) to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the IDS.
1. Select "Self Test".
2. Select "Modules".
3. Select "IC".

Verify the DTC according to the directions on the screen.

If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

Snapshot data table

Fig 1: DLC-2 Location

Courtesy of MAZDA MOTORS CORP.

NOTE:

SNAPSHOT DATA CHART

Snapshot data item	Data contents	Unit	Display content
TOTAL_DIST	Odometer reading when DTC detected	km	Odometer reading when DTC detected (four-digit number indicated)

After completion of repairs, clear all DTCs stored in the instrument cluster. (See CLEARING DTC [INSTRUMENT CLUSTER] .)