LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Manual Control Lever Shaft Seal Removal / Installation >> Removal Note

Removal Note

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • It is not necessary to remove the transmission fluid filter to perform this procedure.
  1. Remove the oil pan. See AUTOMATIC TRANSMISSION OIL PAN (GASKET AND OIL STRAINER) REMOVAL / INSTALLATION , .
  2. Remove the digital transmission range (TR) sensor. See DIGITAL TRANSMISSION RANGE SENSOR REMOVAL / INSTALLATION , .
    Fig 1: Locating Manual Valve Inner Lever Nut
    G04930547Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Do not damage the valve inner lever pin.
  3. Remove the manual valve inner lever nut.
  4. Remove the manual valve inner lever and the parking lever actuating rod.
    Fig 2: Locating Manual Valve Inner Lever
    G04930548Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Do not damage the case fluid pan rail.
  5. Remove the manual control lever shaft spring pin.
    Fig 3: Locating Manual Control Lever Shaft Spring Pin
    G04930549Courtesy of MAZDA MOTORS CORP.
    • Tap lightly on each side of the manual control lever shaft spring pin with a drift punch.
    • Pry the spring pin out of its bore.
  6. Remove the manual control lever shaft.
    Fig 4: Locating Manual Control Lever Shaft
    G04930550Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Do not damage the bore.
  7. Remove the manual lever shaft seal.
Fig 5: Locating Manual Lever Shaft Seal
G04930551Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals