LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Automatic Transmission Oil Pan (Gasket And Oil Strainer) Removal / Installation

Automatic Transmission Oil Pan (Gasket And Oil Strainer) Removal / Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
  2. Place a drain pan under the oil pan.
    NOTE:
    • The transmission heat shield (4.0L) does not have to be removed from vehicle for oil pan removal.
  3. Drain transmission fluid.
    • Remove all the oil pan bolts except for two in the front. Loosen the two bolts. Pry the rear of the oil pan down and allow fluid to drain. After fluid is drained remove the two remaining bolts.
    Fig 1: Locating Bolts
    G04930376Courtesy of MAZDA MOTORS CORP.
  4. Remove the (1) oil pan and discard the (2) oil pan gasket.
    Fig 2: Identifying Oil Pan With Oil Pan Gasket
    G04930377Courtesy of MAZDA MOTORS CORP.
  5. Remove the (1) bolt and the (2) oil strainer.
    Fig 3: Identifying Bolt And Oil Strainer
    G04930378Courtesy of MAZDA MOTORS CORP.
  6. Clean and inspect the oil pan and magnet Clean all mating surfaces.
    Fig 4: Locating Oil Pan Magnet
    G04930379Courtesy of MAZDA MOTORS CORP.
  7. Flush the transmission fluid cooler and transmission fluid cooler lines. See AUTOMATIC TRANSMISSION POWER FLUSHING , .
    CAUTION:
    • Lubricate O-rings with Mazda ATF TYPE 5 or they may be damaged.
  8. Lube and install new O-rings onto the oil strainer. Install a new oil strainer.
    • Position oil strainer on the control valve body.
    Fig 5: Locating O-Rings
    G04930380Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Make sure wire harness is not pinched under filter.
  9. Install bolt.
    Fig 6: Filter Bolt With Torque Specification
    G04930381Courtesy of MAZDA MOTORS CORP.
  10. Position the oil pan magnet in the transmission oil pan.
    Fig 7: Locating Oil Pan Magnet
    G04930382Courtesy of MAZDA MOTORS CORP.
  11. Position a new gasket (2) on the oil pan (1).
    Fig 8: Identifying Gasket And Oil Pan
    G04930383Courtesy of MAZDA MOTORS CORP.
  12. Install and align the oil pan.
    • Loosely install the 18 transmission oil pan bolts.
  13. Tighten the oil pan bolts.
    • Use a crisscross sequence to tighten the oil pan bolts.
    Fig 9: Oil Pan Bolts With Torque Specification
    G04930384Courtesy of MAZDA MOTORS CORP.
  14. Lower the vehicle.
    NOTE:
    • When filling a dry transmission and converter start with a minimum of 3.7 liters (4 quarts).
  15. Fill transmission to proper fluid level. See AUTOMATIC TRANSMISSION PRELIMINARY INSPECTION , .
scientia non olet · About LEMON Manuals