LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (Engine Mechanical [Service Information 3.0L]) >> Crankshaft Front Oil Seal Replacement - 3.0L >> Installation Note

Installation Note

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft front oil seal.
    Fig 1: Locating Vibration Damper And Seal Replacer SST
    G04929468Courtesy of MAZDA MOTORS CORP.
    • Lubricate the seal lip with clean engine oil.
    • Using the vibration damper and seal replacer SST  , install the front oil seal.
  2. Using Vibration Damper and Seal Replacer ST  303-175 (T82L-6316-A) or equivalent, install the crankshaft damper.
    Fig 2: Vibration Damper Bolt With Torque Specifications
    G04929469Courtesy of MAZDA MOTORS CORP.
    • Coat the sealing surfaces of the crankshaft damper with clean engine oil.
    • Coat the crankshaft damper keyway with silicone.
    • Install the crankshaft damper.
  3. Install the crankshaft pulley.
    Fig 3: Crankshaft Pulley Bolt With Torque Specifications
    G04929470Courtesy of MAZDA MOTORS CORP.
  4. Install the drive belt. See DRIVE BELT REMOVAL / INSTALLATION - 3.0L , .
  5. Install the cooling fan blade and fan shroud. See COOLING FAN AND CLUTCH REMOVAL / INSTALLATION -- 3.0L .
  6. Install the air cleaner outlet tube. See AIR CLEANER OUTLET TUBE REMOVAL / INSTALLATION - 3.0L , .
  7. Connect the negative battery cable. See BATTERY DISCONNECT .
scientia non olet · About LEMON Manuals