LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (Engine Mechanical [Service Information 3.0L]) >> Belt TENSIONER Removal / Installation - 3.0L

Belt TENSIONER Removal / Installation - 3.0L

WARNING: This page is about a different car, the 2007 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. See DRIVE BELT REMOVAL / INSTALLATION - 3.0L , .
  2. Remove the belt tensioner bolt and belt tensioner.

    Tightening Torque: 

    Tighten to: 27 N.m {2.0 kgf.m, 20 ft.lbf} 

  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals