LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> B4000 Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical [Intake-Air System 4.0L) >> Throttle Body Removal / Installation - 4.0L

Throttle Body Removal / Installation - 4.0L

WARNING:
  • Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
CAUTION:
  • Throttle body bore and plate area have a special coating and cannot be cleaned, or possible damage to the throttle body may occur.
  1. Remove the air cleaner outlet tube. See AIR CLEANER OUTLET TUBE REMOVAL / INSTALLATION - 4.0L , .
  2. Disconnect the throttle position (TP) sensor electrical connector.
    Fig 1: Disconnecting Throttle Position (TP) Sensor Electrical Connector
    G04308082Courtesy of MAZDA MOTORS CORP.
  3. Disconnect the accelerator cable and the cruise control cable (if equipped).
    Fig 2: Disconnecting Accelerator Cable And Cruise Control Cable
    G04308083Courtesy of MAZDA MOTORS CORP.
  4. Remove the throttle body.
    • Discard the gasket.
    Fig 3: Removing/Installing Throttle Body With Torque Specifications
    G04308084Courtesy of MAZDA MOTORS CORP.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals