On-vehicle Inspection (oil pressure switch inspection)
WARNING: This page is about a different variant/trim than selected.
- Remove the under cover.
- Disconnect the cord assembly connector.
- Start the engine, with gear position in N or P.
- Reaffirm that there is no continuity between cord assembly terminal and ground.
- Firmly depress the brake pedal with the left foot.
- Shift the selector lever to D range.
- Verify that there is continuity between oil pressure switch terminal and ground.
- If not as specified, replace the oil pressure switch. (See OIL PRESSURE SWITCH REMOVAL/INSTALLATION ).
- Connect the oil pressure switch connector.
- Install the under cover.
- Connect the negative battery cable.