Oil Pressure Switch Removal/Installation
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing ATF.
- Disconnect the negative battery cable.
- Remove the under cover.
- Disconnect the cord assembly connector.
- Remove the oil pressure switch.
- Install the oil pressure switch.
Tightening torque
17.1-22.1 N.m {1.75-2.25 kgf.m, 13-16 ft.lbf}
- Connect the oil pressure switch connector.
- Install the under cover.
- Connect the negative battery cable.