LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Emission System (L3 With TC)) >> Charcoal Canister Inspection

Charcoal Canister Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the charcoal canister. (See EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM REMOVAL/INSTALLATION ).
  2. Plug ports A and C, then blow air into port B.
    CAUTION:
    • Do not apply the pressure more than 20 kPa {0.2 kgf/cm2 , 2.8 psi} to the charcoal canister. Doing so will damage the charcoal canister.
  3. Verify that there is no air leakage from the case.
    • If not as specified, replace the charcoal canister. (See FUEL TANK SIDE ).
      Fig 1: Charcoal Canister
      G04324997Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals