LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Trim >> Tire House Trim Removal/Installation

Tire House Trim Removal/Installation

  1. Remove the rear seat. (See REAR SEAT REMOVAL/INSTALLATION .)
  2. Remove the inner scuff plate. (See INNER SCUFF PLATE REMOVAL/INSTALLATION .)
  3. Partially peel back the seaming welt.
  4. Pull the tire house trim outward and detach clips A and locator pins B.
  5. Detach tabs C and remove the tire house trim.
  6. Install in the reverse order of removal.
    Fig 1: Removing/Installing Tire House Trim
    G01344522Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals