LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Front BELTLINE Molding Removal/Installation

Front BELTLINE Molding Removal/Installation

  1. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
  2. Remove the power outer mirror installation screws and move the mirror to access the front end of the front beltline molding. (See POWER OUTER MIRROR REMOVAL/INSTALLATION .)
  3. While partially peeling back the front beltline molding, detach tabs A along the direction (1) shown in the figure.
  4. Remove clip B and front beltline molding.
  5. Install in the reverse order of removal.
    Fig 1: Removing/Installing Front Beltline Molding
    G01344476Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals