Rear Washer Hose Removal/Installation

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION .)
Remove the rear washer hose from the clips.
Partially peel off the right side mud guard and remove the rear washer hose from the clip.

Fig 1: Removing Rear Washer Hose From Clips
Courtesy of MAZDA MOTORS CORP.
Remove the rear washer hose from the washer tank.

Fig 2: Removing Rear Washer Hose From Washer Tank
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.