Power Outside Mirror Removal/Installation

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
Partially peel off the door screen.
Disconnect the connector.
Remove the nuts, and then remove the power outside mirror.

Fig 1: Removing Power Outside Mirror
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.