LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Manual A/C-Heater Systems - HVAC >> Pressure Cutoff Switch >> Removal and Installation

Removal and Installation

Fig 1: Removing/Installing Pressure Cut-Off Switch
G01162264Courtesy of MAZDA MOTORS CORP.
  1. Remove the pressure cut-off switch.
    1. Disconnect the A/C pressure cut-off switch electrical connector.
    2. Remove the A/C pressure cut-off switch.
  2. To install, reverse the removal procedure.
    1. Lubricate the O-ring seals with PAG Compressor Oil.
scientia non olet · About LEMON Manuals