LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Disc Brake System & Drum Brake System) >> Removal & Installation >> Brake Pedal >> Removal & Installation (Manual Transmission)

Removal & Installation (Manual Transmission)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Mazda B4000, 2004 Mazda B3000, 2004 Mazda B2300, 2003 Mazda B4000, and 2003 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the brake master cylinder push rod. See Fig 1 . Remove the hairpin clip. Separate the stoplight switch and the brake booster push rod from the brake pedal pin. Remove the brake booster push rod bushing.
  2. Disconnect the Clutch Pedal Position (CPP) switch electrical connector. See Fig 2 . Disconnect the clutch pedal master cylinder rod. Remove the bulkhead sound insulator.
  3. Remove power brake unit-to-firewall nuts. Remove power brake unit from firewall and support the brake master cylinder and power brake booster in the engine compartment. Remove brake pedal bolts. Remove the brake pedal.
  4. To install, reverse removal procedure. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS  .
Fig 1: Removing Brake Pedal (Manual Transmission)
G00007249Courtesy of MAZDA MOTORS CORP.
Fig 2: Disconnecting Clutch Pedal Position Switch Electrical Connector
G00281127Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals