LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Disc Brake System & Drum Brake System) >> Bleeding Brake System >> Pressure Bleeding

Pressure Bleeding

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Mazda B4000, 2004 Mazda B3000, 2004 Mazda B2300, 2003 Mazda B4000, and 2003 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all dirt from and remove the brake master cylinder filler cap and fill the brake master cylinder reservoir with the specified brake fluid.
    2. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the instructions of the manufacturer when installing the adapter.
  2. Install the bleeder adapter to the brake master cylinder reservoir, and attach the bleeder tank hose to the fitting on the adapter.
    3. NOTE: Bleed the longest line first. Make sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.
  3. Place a box end wrench on the right rear bleeder screw. Attach a rubber drain tube to the right rear bleeder screw, and submerge the free end of the tube in a container partially filled with clean brake fluid. See Figure .
  4. Open the valve on the bleeder tank. Loosen the right rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the right rear bleeder screw to specification and remove the rubber hose. See TORQUE SPECIFICATIONS  .
  5. Continue bleeding the rest of the system, going in order from the left rear bleeder screw to the right front disc brake caliper bleeder screw, ending with the left front disc brake caliper bleeder screw. Close the bleeder tank valve. Remove the tank hose from the adapter, and remove the adapter.
scientia non olet · About LEMON Manuals