LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (Engine Mechanical [Lubrication System]) >> Engine Oil Level Inspection

Engine Oil Level Inspection

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the vehicle on level ground.
  2. Warm up the engine.
  3. Stop the engine and allow approx. 5 min  before continuing.
  4. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
  5. Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick.
    • If the oil level is below the L mark, add oil.
    NOTE:
    • The TYPE A dipstick is graduated in 0.5 L intervals as a reference for oil replenishment.
  6. Install the dipstick.
  7. Install the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
    Fig 1: Inspecting Engine Oil Level
    G03701816Courtesy of MAZDA MOTORS CORP.