LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (Exterior Trim) >> Roof Molding Removal/Installation

Roof Molding Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION .)
  2. Remove the head impact pad. (See HEAD IMPACT PAD REMOVAL/INSTALLATION .)
  3. Remove the right side rear cooler duct No.1. (See REAR COOLER DUCT REMOVAL/INSTALLATION .)
  4. Remove the nut, and then pull the molding up.
  5. Install in the reverse order of removal.
    Fig 1: Identifying Roof Molding Removal/Installation Procedure
    G03701308Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals