LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 421 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures (Two-Step Deployment Control System) >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner seat belt

Pre-tensioner seat belt

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the b-pillar lower trim. (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  2. Remove the pre-tensioner seat belt and connect the SST  (Adapter harness) as shown in Fig 1. (See FRONT SEAT BELT REMOVAL/INSTALLATION (STANDARD DEPLOYMENT CONTROL SYSTEM) , FRONT SEAT BELT REMOVAL/INSTALLATION (TWO-STEP DEPLOYMENT CONTROL SYSTEM) .)
  3. Install the pre-tensioner seat belt.
    Fig 1: Connecting SST (Adapter Harness) To Pretensioner Seat Belt
    G03700923Courtesy of MAZDA MOTORS CORP.
  4. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
    Fig 2: Connecting SST (Deployment Tool) To SST (Adapter Harness)
    G03700924Courtesy of MAZDA MOTORS CORP.
  5. Connect the SST  (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  6. Verify that the red lamp on the SST  (Deployment tool) is illuminated.
  7. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
  8. Press the activation switch on the SST  (Deployment tool) to operate (deploy) the pre-tensioner seat belt.
    Fig 3: Identifying Activation Switch On SST (Deployment Tool)
    G03700925Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals